Installation - Ar-Pre-P - Manitowoc ArcticPure Pure AR-10000-P Manuel D'installation, D'utilisation Et D'entretien

Section 2

Installation - AR-Pre-P

NOTE: If the AR-Pre-P is being retrofitted to an existing
ArcticPure® Plus system, shut off the incoming water supply,
relieve the filter pressure by removing the existing filter
cartridge(s), and disengage the water inlet line. A small
quantity of water will be vented from the cartridge body.
1. Mark and drill the mounting holes for the AR-Pre-P.
2. Insert the precut tubing into the outlet fitting of the AR-
Pre-P head.
3. Insert opposite end of the tubing into the inlet fitting of
the primary filter assembly.
The fitting will grip before it seals. Tubing must be pushed
into the tube stop to prevent leaks.
4. Pull on the tubing to be sure it is secure. If the tubing
releases, refer to the Troubleshooting section of this
manual to reinstall.
5. Align the prefilter mounting keyhole slots with the
predrilled holes.
6. Install mounting screws and tighten.
7. Insert incoming water line into the inlet port of the
AR-Pre-P. Follow notes and steps 1-3 under "Installation -
AR-10000-P/AR-20000-P/AR-40000-P".
Part Number: 000016341 Rev00 1/21


Notice
8. Remove the protective cap from the cartridge.
9. Inspect the cartridge and o-rings for damage. See
Recommended Replacement Parts List if replacement is
required.
,
Do not use petroleum jelly to lubricate o-rings.
10. Lubricate o-rings with food grade lubricant - Do not use
petroleum jelly.
11. With the product label facing to the left, insert the
cartridge into the filter head. Rotate 1/4 turn to the right
to secure. Product label will face forward.
Installation
Caution
9