Installation; General; Safety - Manitowoc ArcticPure Pure AR-10000-P Manuel D'installation, D'utilisation Et D'entretien

General

These instructions are provided to assist the qualified
installer. Check your local Yellow Pages for the name of the
nearest Manitowoc distributor, or call Manitowoc Ice for
information.
The ArcticPure® Plus water filtration systems are designed
to reduce coarse and fine particulate matter from the
incoming potable water supply. Chlorine will be reduced in
the water so as not to adversely affect the ice produced or
the equipment components. Scale inhibitor is automatically
fed into the water to inhibit the formation of scale on
water solenoids and evaporator plates. The IAPMO R&T
mark indicates that these products have met certification
requirements under the NSF/ANSI & CSA standards listed in
the Performance Data Sheet. The UPC mark indicates that
these products have met the applicable U.S. and Canadian
requirements for plumbing products.
• DO NOT install on line pressure above 125 psi (862 kPa).
• DO NOT install on hot water line. Maximum temperature
allowed is 100°F (38°C).
• DO NOT install in direct sunlight.
• DO NOT reverse connections. The system must be
installed with the inlet and outlet as labeled.
• DO NOT install ArcticPure® Plus filter systems in locations
where they can be damaged by other free-standing
equipment.
• PROTECT from freezing.
• INSTALLATION must comply with existing state or local
plumbing codes.
This piece of equipment has American sizes on hardware. All
metric conversions are approximate and vary in size.
AR-Pre-P, AR-10000-P, AR-20000-P and AR-40000-P systems are certified by IAPMO R&T against CSA B483.1; NSF/ANSI 372 for
Low Lead Content; NSF/ANSI 42 and/or *NSF/ANSI 53 for the reduction of claims listed in the Performance Data Sheet.
*NSF/ANSI 53 Cyst reduction claims are valid only when system flow is restricted at or below the specified range and/or
as specified in the ice machine capacity ranges on page 5. System flow rates should be verified after installation to ensure
filterable cyst reduction per the above.
Please see ice machine manufacturer's technical publications for internal flow controller maximum operating flow rate
specifications.
Part Number: 000016341 Rev00 1/21
Section 2

Installation

Safety

Always follow these safety precautions when installing and
operating the water filter system.
DO NOT use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.
DO NOT use a torch or other high temperature sources
near filter or cartridge.
https://www.iapmort.org/media/5271/rt_markguidelines.pdf
n
Warning


Notice
7