Location; Water Service; Important; Assembly - Ar-10000-P/Ar-20000-P/Ar-40000-P - Manitowoc ArcticPure Pure AR-10000-P Manuel D'installation, D'utilisation Et D'entretien

Installation

Location

ArcticPure® Plus water filtration systems must be located
on the incoming cold water line and preferably away from
heavy traffic areas. The system must be mounted on a wall
or structure that will support the weight of the system when
filled with water.
This product is designed for cold water use only (less than
100°F [38°C]). Passing hot water through this product
may seriously damage filter housings and/or cartridges
and affect warranty coverage.

Important

Do not disassemble manifold head. No user serviceable
parts are available. The entire manifold head is the only
available replacement part.
ArcticPure® Plus systems may be used with metal or non-
metallic piping systems.
NOTE: Any non-metallic fittings used in the installation must
be of adequate rating for the line pressure.

Water Service

All ArcticPure® Plus systems come with 3/8" Parker
connections on the inlet and outlet ports.
Parker connections are suitable for use with the following
tubing:
• Polyethylene
• Nylon
• Polyurethane
• Seamless Brass (soft)
• Seamless Copper (soft)
• Seamless Mild Steel (soft)
DO NOT use with hard metal tubing such as:
• Stainless steel
• Chrome plated copper
• Hard metal polished tubing
8


Notice


Notice

ASSEMBLY - AR-10000-P/AR-20000-P/AR-40000-P

NOTE: The head/bracket will be packed separately from the
filter cartridge in the product box.
1. Locate position to mount the filter system. Be sure
to leave enough clearance (a minimum of 2" [5 cm]
beneath the filter cartridge length is recommended) to
allow for cartridge change out.
2. Mark and drill mounting holes.
3. Mount filter head, using key hole slots in the mounting
bracket.
4. Remove the protective cap from the cartridge.
5. Inspect the cartridge and o-rings for damage. See
Recommended Replacement Parts List in Replacement
Filter Part Numbers if replacement is required.
,
Do not use petroleum jelly to lubricate o-rings.
6. Lubricate o-rings with food grade lubricant - Do not use
petroleum jelly.
7. With the product label facing to the left, insert the
cartridge into the filter head. Rotate 1/4 turn to the right
to secure. Product label will face forward.
Part Number: 000016341 Rev00 1/21
Section 2
Caution