Fitting The Wall Mounting Bracket; Use - Maxx-world Z 08862 Mode D'emploi

Fitting the Wall Mounting Bracket

CAUTION!
• Choose a suitable place for the wall mounting bracket which should be as dry and
close to a plug socket as possible.
• Make sure that you do not drill into or destroy any pipes or cables. Find out
where possible pipes or cables may run and avoid them.
1. Now hold the wall mounting bracket against the chosen location and mark the drill
holes using a pencil.
2. Then attach the wall mounting bracket to the wall using the associated screws and
dowels.
3. If the barrel connector is not already attached in the wall mounting bracket, plug it into
the holder which is provided for this purpose.

Use

CAUTION!
• Never hold the nozzles close to parts of your body during use and do not place
your hands inside the nozzles. They could become stuck to the device/injured. If the
vacuum cleaner becomes fi rmly attached due to suction, turn it off immediately .
• Keep the nozzles away from animals during operation. Never attempt to vacuum ani-
mals using the device. They could become stuck to the device/injured. If the vacuum
cleaner becomes fi rmly attached due to suction, turn it off immediately.
• Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
• Make sure that the MAX marking on the dust container is not exceeded when liquids
are sucked up.
• Always hold the device horizontally when liquids are sucked up. Make sure that
sucked-up liquids do not get into the motor unit.
• Do not in any case vacuum up the following:
– smouldering ashes, cigarette butts, matches etc.
– fl ammable or ignitable materials
– very fi ne dust (e.g. cement dust), ash or toner
– hard, pointy objects such as bigger glass shards
• Empty and clean the dust container after each use (see the "Cleaning and Storage"
chapter).
• Do not use the device when it is connected to the mains adapter.
1. Remove the mains adapter from the device.
2. Insert one of the attachments into the suction opening on the front of the collecting
container.
3. Select an attachment. The attachments are inserted into the suction opening on the
front of the device:
19 EN