Mounting And Operation - Bosch Professional GWS 7-100 Notice Originale

OBJ_BUCH-1188-003.book Page 16 Tuesday, August 13, 2013 2:49 PM
16 | English
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly in-
crease the exposure level over the total working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Grinding, preparation
Cutting, preparation
Cutting stone, brick and tiles,
preparation (recommendation)
Removing paint, preparation
Removing rust, preparation
Drilling tiles, preparation
Mounting the quick-clamping nut
Dismounting the quick-clamping
nut
1 609 92A 0EE | (13.8.13)
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working pe-
riod.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep hands warm, organise work patterns.
Figure Please observe
1
30°
2
3
4
5
6
7
8
Page
243 – 244
245 – 246
247 – 248
249
250
251
251 – 252
252
Bosch Power Tools