Saneo 12000BTU Mode D'emploi page 37

This machine has two water evacuation methods : manual evacuation and continuous evacuation.
1. Manual evacuation (see picture below) :
- When the water tank is full, turn off the unit and unplug it. Move the unit carefully so as not to spill
water from the tank.
- Place a container under the drain hole at the back of the unit.
- Remove the plug from the drain hole, the water will flow into the container.
Drainage hole
2.Continuous evacuation (only to be used in dehumidification mode, see image below) :
- Remove the plug from the drain hole.
- Install the water drain pipe in the continuous drain hole.
- Place the other end of the exhaust pipe in an empty container.
MAINTENANCE
1. Before cleaning, disconnect the unit from the power
supply.
2. Do not use chemicals to clean the unit.