Saneo 12000BTU Mode D'emploi page 36

2. Open the individual components of the sealing plate, adjust their opening distance to bring both ends
of the assembly into contact with the window frame.
CAUTION: The flat end of the exhaust pipe joints must be snap-fastened into place and the pipe must
not be deformed or twisted significantly (more than 45°). Make sure that the ventilation of the exhaust
pipe is not obstructed.
Installing the air conditioner
1. Once the exhaust pipe is attached to the air conditioner and the window seal plate is installed, place
the air conditioner in front of the window at a distance of at least 50 cm between the unit and the
window and surrounding objects.
2. Pull the exhaust pipe and snap the flat end of the exhaust pipe fittings into the hole in the window
sealing plate (see images below).
IMPORTANT : The flat end of the exhaust pipe connections must be clipped into place. The pipe must
not be deformed and must not show any significant torsion (greater than 45°). Check that the exhaust
pipe is not blocked.
IMPORTANT :
The length of the exhaust pipe is from 28cm to 150cm. Do not use extension cords or replace the hose with
others, as this may cause malfunction. The exhaust pipe must not be blocked, otherwise it may cause
overheating.
Water drainage