Setting The Table For Horizontal Or Bevel Cutting - Build Worker BSC90-440 Manuel D'instructions

4.Cuts per minute: 750-1500/min
5.Table size : 340x245 mm
6.Table tilt:0 ---- 45 degree
7.Net weight:11kg
8.Gross weight:/12kg
motor specifications and electrical
requirements
This machine is equipped with a 750~1500
RPM motor. It is wired for operation on
230 volts, 50 Hz. alterating current.
For replacement motor refer to parts list
in this manual.
CONNECTING TO POWER SUPPLY
GROUND THIS POWER TOOL CAN
CAUSE AN ELECTRICAL SHOCK
PARTICULARLY WHEN USED IN DAMP
LOCATIONS CLOSE TO PLUMBING.
IF ALL ELECTRICAL SHOCK OCCURS
THERE IS THE POTENTIAL OF A
SECONDARY HAZARD SUCH AS YOUR
HANDS CONTACTING THE SAW BLADE.
if you are not sure that your outlet, is
properly grounded, have it checked by a
qualified electrician. Your unit is for use
on230 volts, This power tool is equipped
with a 3 - conductor cord and grounding
type plug approved by VDE 0620.
plug power cord into a 230v properly
grounded type outlet.
If you are not sure that your outlet boxes
properly grounded, have it checked by a
qualified electrician.
The use of any extension cords
will cause some loss of power. Use
only 3wire extension cords which
have grounding type plugs and 3-pole
receptacles which accept the tools plug.
WARNING: DO NOT PERMIT FINGERS
TO TOUCH THE TERMINALS OF PLUGS
WHEN INSTALLING OR REMOVING THE
PLUG TO OR FROM THE OUTLET.
Assembly
WARNING: FOR YOUR OWN SAFETY,
NEVER CONNECT PLUG TO POWER
SOURCE OUTLET UNTIL ALL
ASSEMBLY STEPS ARE COMPLETE ,
AND YOU HAVE READ AND UNDERSTAND
THE SAFETY AND OPERATION
AL INSTRUCTIONS.
Lift the saw by the frame and base and
place scroll saw on work bench.
Familiar yourself with the controls
and features of this scroll saw indicated
in the illustration.
NOTE: When you mount the frame to the
base, at first you must plaste two taper
pins (see No.39 and No.40in exploding
diagram)into holes on base across the
frame for orientation. Then you mount four
bolts and tension them.
SETTING THE TABLE FOR
HORIZONTAL OR BEVEL CUTTING
The scroll saw work table can be titled
to the left for bevel cutting up to 45
degrees from the 0 degree or horizontal cutting
position.
A bevel scale is provide under the work
table as a convenient reference for
setting the approximate table angel for
bevel cutting.