CDVI Digicode CBB Manuel D'installation page 16

INSTALLATION MANUAL
CBB
Self-contained Keypad - braille keys
B. Setting code length
1. Enter the master code twice.
- F or the fi rst use, the factory
master code is: 1 2 3 4 5.
*
2. Press 4 to input the number of digits
in the codes.
- G reen LED lights on for 1 second.
- E nter 4, 5 or 6 for number of digits.
*
- Press and # to confi rm
- T he green LED lights on for 1 second
to confi rm the new code length.
*
3. Press 5 to change the master code.
- G reen LED lights on for 1 second.
- E nter the 4, 5 or 6 digits of the new
master code.
- T he green LED lights on during 1 second
to confi rm the new master code.
You MUST change the master code
before you exit from programming
if you have changed the digit length
4. Press # to exit from the programming
mode.
The red LED lights off to confi rm
that the keypad is in stand-by operating mode.
Red LED fl ashing 4 times indicates
a data computing error.
C. Programming a New Master Code
1. Enter the master code twice.
- F or the fi rst use, the factory
master code is: 1 2 3 4 5.
- R ed LED lights on to confi rm
e ntry in programming mode.
*
2. Press 5 to program the master code.
- G reen LED lights on for 1 second.
- E nter 4, 5 or 6 for number of digits.
*
- Press and # to confi r
- T he green LED lights on for 1 second
to confi rm the new master code.
3. Press # to exit from the programming
mode.
The red LED lights off to confi rm
that the keypad is in stand-by
operating mode.
cdvi.com
16
cdvigroup.com
All manuals and user guides at all-guides.com
D. Adding, changing or deleting
E. Time outputs
a user code
Relay 1
Group 1: From location 00 to location 59,
Relay 2
Group 2: From location 60 to location 79.
Relay 3
Group 3: From location 80 to location 99.
Master code Master code
1. Enter the master code twice.
- F or the fi rst use the factory master code
is: 1 2 3 4 5.
- T he red LED's light on to confi rm entry
in programming mode.
2. Enter the user location
to be programmed (from 00 to 99).
- I f the location is free, the green LED's light
on during 1 second, enter the 4, 5 or 6 digits
of the code.
- I f the location is occupied, the red LED's
fl ashes 4 times.
- E nter the 4, 5 or 6 digits of the code
or enter 0 0 0 0 0 0 or 0 0 0 0 0 or 0 0 0 0
to cancel the existing code.
- I f the Pin code is already programmed
or is identical to the master code,
then 4 beeps are emitted.
- C odes 0 0 0 0 0 0 or 0 0 0 0 0
or 0 0 0 0 serve to cancel an existing
code and hence cannot be used
as an usual code.
3. Press # to exit from the programming mode.
The red LED lights off to confi rm that the
keypad is in stand-by operating mode.
1. Enter the master code twice.
- F or the fi rst use, the factory
master code is: 1 2 3 4 5.
- R ed LED lights on to confi rm
e ntry in programming mode.
EN
RED Led
lights on