Kenmore 35712 Mode D'emploi page 5

Pre p a r i n g f o r u s e
SEMI-PERMANENT INSTALLATION
If required, your appliance can also be
installed semi-permanently (Fig. E).
30 cm
11,8 inches
Proceed as follows:
• Drill a hole (ø 134 mm) in an outside wall or
through a window pane.
Respect the dimensions and height of the
hole given in figure F and G.
in the window in the wood-
pane en kickboard
of a French
window
F
Keep the air hoses as short and free of
curves as possible to avoid constrictions.
6
All manuals and user guides at all-guides.com
• Fit the wall flange
• Fit the air exhaust hose
• Fit the end of the hose
30 cm
11,8 inches
E
NOTE: When installing the air conditioner
semi-permanently, you should leave a door
slightly open (as little as 1 cm) to guarantee
correct ventilation.
in the wall: you are
recommended to
insulate the sec-
tion of wall using
suitable insulation.
10
into the hole.
hose located on the rear side of the appli-
ance. (fig. A page 5).
10
flange as shown in fig. G.
11
in the relevant
11
to the wall
G
MAX100 cm
MAX 39 inches
MIN 35 cm
MIN 14 inches