Operating Instructions; Master 200 Solid State Control With; Electromechanical Timer; Modes - Garland Master Serie Manuel D'installation, D'utilisation Et D'entretien

OPERATING INSTRUCTIONS

Master 200 Solid State Control with

Electromechanical Timer

Modes

In Off Mode
When the oven is off , there are no lights or indicators.
Start Up
Press the COOK/OFF/COOL DOWN rocker switch to the
"COOK" position. The green lamp will light indicating the
oven is powered in cook mode.
The oven will begin to heat to the temperature set on the
thermostat dial. The amber lamp will light indicating the heat
is active. As the heat cycles on and off to maintain the set
temperature this light will go on and off accordingly.
The door must be closed for the oven to operate in cook
mode. Opening the door will cause the heat to stop and the
motor and fan will shut off . This is a safety feature.

Fan Speed

The fan speed can be either high (1725RPM) or (1150RPM).
The fan speed is controlled by the left rocker switch marked
high and low.

Lights

The oven lights are activated by pressing the light switch
on the control panel. This is a momentary switch and the
lights will stay lit as long as this button is held in the on
position. Lights will work whenever there is electrical power
connected to the oven.

Cool Down

Pressing the COOK/OFF/COOL down rocker switch to the
COOL DOWN position activates the fan and motor to cool
the oven cavity. The door must be open slightly for the fan
and motor to start. The heat is not active in this mode.
Optimal cool down will be achieved with the door open
slightly. Opening the door too far will shut the fan and motor
off . This is a patented safety feature.
Pressing the button to the OFF position cancels the cool
down and turns the oven off .

Temperature

The temperature range is from 150° to 500°F (66°C) to 250°C)
is controlled by rotating the temperature dial and aligning
the indicator to the desired temperature.
10 Part Number 1955203 rev 4 4/15