Foppapedretti HURRA Notice D'utilisation page 14

• ENGLISH •
TO INSTALL / USE
THE REAR WHEELS (fig.1, 2)
Fitting the rear wheels: Insert the rear wheel group into the end of the tubes of the rear legs. The wheel
supports are correctly assembled when the metal pins "a" are locked in the corresponding holes on the
tubes of the chassis
Removing the rear wheels: Press the locking device "a", in the lower part of the leg and keeping it
pressed, remove the rear wheel group.
FRONT WHEELS (fig. 3)
Fitting the front wheels: Lift the chassis with one hand and insert the front wheels. A click will indicate
that it has been fitted correctly. Check that both the wheels have been fastened correctly, if they are
pulled downwards they should not be released.
Removing the front wheels: Press metal button "A" on the inside, to take the wheels off.
HOW TO OPEN THE PUSHCHAIR (fig. 4, 5, 6)
CAUTION: make sure that the child, and any other children, are at a safe distance away when carrying
out this step.
The moving parts of the stroller must not for any reason come into contact with the child's body.
Unhook the locking device.
Push the front part of the stroller forwards.
Press the rear lever "A" downwards with your foot, until it opens completely.
CAUTION: before use check that the stroller is locked in the open position.
PARKING BRAKE
WARNING: The parking device shall be engaged when placing and removing the children.
WARNING: Never leave child unattended.
WARNING: Never leave the stroller on a slope with the child inside, even with the brakes on.
To apply the brake (fig.7): Press the brake lever, push the pushchair forward gently to ensure the brake
has been applied correctly.
To release the brake (fig.8): lift the lever.
TO DIRECT THE FRONT WHEEL (fig. 9, 10)
Turn the direction of the front wheels: Press down the locking arm to block the swivel wheels.
Fix the direction of the front wheels: Lift the locking arm to release the swivel wheels lock.
TO OPEN AND FASTEN THE SAFETY BELT (fig. 11, 12, 13, 14)
Important: The safety belt has to be used always and only correctly fasten, including all components,
as shown in figure. Apply the brake before placing your baby in the pushchair.
Adjust the strap length with the adjustment slides (fig.11)
Releasing the buckle: Press button "A" and pull out the parts.
Place your child in the stroller and adjust the harness to fit him/her.
Clip the buckle: insert part "a" into part "b" and then into the buckle "c", you will hear a click when it
is fastened correctly. Always use the restraint system attached correctly.
IMPORTANT: If baby is less than 6 months old, the harness belts must be inserted through the lower
14