Step 12 Completing The Installation - Samsung DW80M9 Serie Guide D'installation

STEP 12 COMPLETING THE INSTALLATION

1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned off before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
CAUTION
5. Check if the dishwasher turns on properly and check also if there is any leak. If there is no
problem, turn the dishwasher off . Skip steps 6 through 10 and go to step 11.
6. If the leakage check code of "LC" appears on the window panel, press and hold the Start
button for more than 3 seconds to start draining. When the draining is complete, unplug the
dishwasher and close the water supply valve.
7. Check if the inlet valve leaks. If so, reconnect the 90 º fi tting with the hot water supply line
because they are not properly connected.
8. Once the leak is stopped, lay down the dishwasher as shown, and wipe out moisture from
the water leakage sensor.
9. Plug the dishwasher. Then, open the water supply valve and try a cycle.
10. If the "LC" information code continues to appear on the window panel, contact a local
service center.
11. Confi rm that the kick plate gasket is on the bottom of the kick plate. To install the kick plate,
refer to the fi gure below.
DW9900M-00183B-01_EN.indd Sec3:21 DW9900M-00183B-01_EN.indd Sec3:21
Water leakage sensor
installing the dishwasher _21
12/27/2016 6:22:52 PM 12/27/2016 6:22:52 PM