Led Status - Gear4 StreetParty Wireless Notice D'utilisation

charged or is connected to a power source
and is switched ON.
■ Press and hold the
at the front of the speaker starts flashing.
(The speaker will have 10 minutes to
connect/pair with your device.)
■ 'Gear4 SPW' will appear on your Bluetooth
device.
■ Select 'Gear4 SPW' and enter the password
'0000' if necessary.
■ The LED will stop flashing when your device
has successfully paired.
Note: StreetParty Wireless can only be paired to
one electronic device at any given time.
For use with
other audio devices:
■ Plug one end of the 3.5mm audio cable
(supplied) into your personal electronic
device and connect the other end into the
AUX IN port at the back of the speaker.
Note: Speaker volume cannot be adjusted by
the speaker volume controls.
Speaker phone functions:
■ To answer a call – press the
■ To reject a call – press and hold the
button for 1 second.
■ To end a call - press the
button until the LED
button
button.
■ To switch call signal between speaker and
phone - press the Audio Source icon
displayed on the iPhone screen (when a call
has been initiated).

LED Status:

LED SyNC INDICaTOr (FrONT):
■ Power OFF – LED OFF
■ Power ON – LED ON (blue)
■ Pairing Mode – LED FLASHING (blue/red)
LED CharGING INDICaTOr (BaCK):
■ Fully Charged – LED ON (red)
■ When Charging – LED ON (blue and red
Register your StreetParty Wireless to activate
your warranty and receive product updates at
www.gear4.com/register
Copyright © 2012 Disruptive Limited. All rights
reserved. Reproduction in part or in whole is
prohibited. GEAR4 and StreetParty are trade
marks of Disruptive Limited. iPhone and iPod
touch are trade marks of Apple Inc., registered
in the U.S. and other countries. iPad is a trade
mark of Apple Inc. App Store is a service mark
of Apple Inc.
The Bluetooth word mark and logos are
®
registered trademarks of Bluetooth SIG, Inc.
User Manual | StreetParty Wireless | GEAR4
together)
3