OHAUS RS232 Manuel D'instructions page 4

EN-2
SETUP DEFINITIONS
PRINT / Stable - On
PRINT / Auto Print – Continuous
PRINT / Auto Print – On Stable
PRINT / Auto Print – (xx) sec
PRINT / Auto Print – Off
RS232 / RS232 –Off
RS232 / Baud, Parity, Handshake
CONNECTION
The RS232 Interface Kit cable terminates with a 9 pin Sub-D female connector.
Active pins: Pin 2 = TXD, Pin 3 = RXD, Pin 5 = Ground, Pins 4 and 6 are connected for hardware
handshake, Pin 7 = CTS, Pin 8 = RTS.
The Interface connector will connect directly to a computer, an Ohaus printer and many other printers.
OPERATION
RS232 OUTPUT
With the Adapter installed the balance will operate in one of the following three ways:

RS232 = on, Auto Print = off, Stable = on or off
Pressing PRINT will send the display data.
If Stable is set to On, the balance will wait for a stable reading before sending data.

RS232 = on, Auto Print = on, Stable = on or off
The balance will automatically send data based on the settings in the Menu.
If Stable is set to On, only stable values will be sent.

RS232 = off
The interface is turned off. During battery operation, this saves significant power.
Data sent from the Interface is in standard ASCII format terminated with a [CRLF] (carriage return-
line feed). The output format is as follows:
Scout Pro (SPx) Output:
Output Format 1 (for the models 303/123/202/402/602/2001/6001/
401FZH/601FZH/6000FZH):
Output String:
[weight]
[space]
[unit]
[space]
[stability indicator]
[space]
[Legend]
Note: All of the fields have fixed length.
Balance transmits stable data only.
Balance repeatedly sends data as fast as possible.
Balance automatically outputs data upon stability.
Balance sends data every (xx) seconds.
Only sends data when PRINT is pressed.
Turns Interface off, saving battery power.
Set parameters to match printer or computer.
12 characters (right justified)
1 character
5 characters
1 character
1 character; "?" when unstable, blank when stable
1 character
10 character
RS232 Interface