Battipav E..GO Serie Mode D'emploi page 40

GB
TRANSPORT WHEEL ASSEMBLY
8
a) take out both wheel supports.
9
b) with a 17 mm wrench, install the transport wheels.
CHECKING BEFORE USE
10
• Before any cutting operation, make sure that the water level inside the tank is the same as the one indicated in the picture.
THE E.GO MACHINE HAS BEEN DESIGNED FOR WORKING WITH WATER.
• Make sure that the power supply cable does not interfere with the cutting operations.
11
BEFORE USING THE MACHINE, CHECK THERE IS POWER SUPPLY.
CONNECTING TO POWER SUPPLY
THE MACHINE IS TO BE CONNECTED TO THE POWER SUPPLY BY A RESIDUAL CURRENT CIRCUIT BREAKER
(RCCB) WITH THE FOLLOWING CHARACTERISTICS:
RCCB In 16 A Id 30 mA
N.B. To ensure correct functioning, periodically check the efficiency of RCCBs by pressing the push-button on the front of the device.
• Make sure that the section of the power supply cable cores has been measured according to the starting current and its length.
For cables up to 50 m long, a section of 4 mm
• Before connecting the machine to the power socket, check that the power supply voltage corresponds to that shown on the
plate on the machine.
• The machine must be connected to an effective earth wire. In case of doubt, do not connect the machine.
IN THE EVENT OF REVERSE MOTOR ROTATION, INVERT THE TWO PHASE PINS INSIDE THE POWER PLUG, AS
INDICATED BELOW: only for codes art.8000/T380
33
• with a screwdriver with a slotted impression, press in the appropriate seat and turn the two phase pins;
• check the correct direction of rotation.
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment, disconnect the machine from the supply mains.
Unscrew the knobs and the locking nut on the disc cover and remove it.
Remove the blade fixing nut using the 30 mm spanner and the 5 mm Allen wrench.
12
THE BLADE FIXING NUT HAS A LEFT-HAND THREAD.
• Install the new blade, checking for correct direction of rotation as clearly indicated on the tool.
• Tighten the blade and put the blade cover guard back in position.
IN ADDITION TO THE KNOBS ALWAYS REASSEMBLE THE LOCKING NUT ON THE DISC COVER.
Ø300 mm DIAMOND BLADE ASSEMBLY
For a correct use of the machine with Ø 300 mm tools, the cutting head stroke register must be adjusted. Proceed as described below:
• Install the Ø 300 mm tool as indicated in the paragraph (diamond blade assembly / disassembly).
13 14
• Loosen the limit stop register located near the cutting head locking lever.
15
• By means of the locking lever, secure the motor head so as to be able to move the diamond part of the tool inside the
groove of the working table.
DO NOT PUT THE CUTTING TOOL IN CONTACT WITH THE BOTTOM OF THE WORKING TABLE GROOVE.
16
• Put back the adjusting screw supporting the frame pin, and secure it with the two locking nuts.
BEFORE USING A Ø 350 mm CUTTING TOOL AGAIN, ALWAYS CHECK THE CORRECT POSITION OF THE CUTTING
HEAD LIMIT STOP REGISTER.
CONTROL DEVICES
17
The E.GO / EGO PLUS machine is equipped with a control board made up of:
40
is enough.
2
Battipav srl