Residual Risk - Battipav VIP Serie Mode D'emploi

GB
CUTTING ON THE TABLE
BEFORE STARTING THE CUTTING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT
10
AT LEAST 150 cm ARE LEFT FREE AROUND THE MACHINE. IN ORDER TO WORK IN SAFETY
CONDITIONS, DO NOT LET OTHER PEOPLE REMAIN NEAR THE MACHINE DURING THE CUTTING
OPERATIONS. BEFORE PERFORMING THE CUTTING OPERATIONS, MAKE SURE THAT THE
MATERIAL IS PROPERLY LEANED AGAINST THE TILE STOPPER.
• Arrange the piece to be cut on the working table at the desired measurement;
11
• Start the machine and wait until cutting blade cooling water comes out, adjusting the necessary amount
11
by means of the water on-off valve located on the blade guard, and cut;
7
CUTTING A SURFACE AT 45°
Before positioning the motor head, make sure that:
• the machine is off; • the cutting tool is not moving;
Referring to the graded scale located on the machine upright, move the motor head to the jolly position and
14
tighten the knobs.
• With the locking lever, lower the cutting head until placing the blade some millimetres below the table level.
13
• Position the piece to be cut on the working table and perform the cutting operation.
13

RESIDUAL RISK

During the design phase, BATTIPAV SRL paid particular attention to the aspects that may generate risks for the
safety and health of operators.
In spite of this, there are still some potential risks, which are described below:
Danger of presence of electric current:
The machine has an internal electric system.
CONNECT THE MACHINE TO A SYSTEM WITH DIFFERENTIAL PROTECTION AND EFFECTIVE
EARTH WIRE.
Danger of prolonged exposure to noise:
The continuative use of the machine causes an exposure to noise levels above 85 dB (A).
OPERATORS MUST USE PROPER EAR DEFENDERS.
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 10) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE
SUPPLY MAINS.
MOTOR CARRIAGE ADJUSTMENT
18
The motor carriage is provided with a register for the vertical play adjustment.
If any excessive play of the motor carriage should take place, act as follows:
28
Battipav srl