Symbols And Signs - Battipav VIP Serie Mode D'emploi

GB
BEFORE ANY APPLICATION.

SYMBOLS AND SIGNS:

Danger/prohibition stickers are applied to the machine where necessary. Look at these prior to using the machine.
24
A1 Use of prescribed PPE obligatory (Safety eyewear and earmuffs)
A2 Read operating instructions before each use.
A3 Warning!
B1 Cut setting 45°
MANUFACTURER AND MACHINE
The nameplate shown is fitted directly on the machine. It indicates all the references and information necessary
for safe operation.
A Machine model
23
B Item
C Serial number
D Power supply voltage
E Power supply frequency
F Current absorption
G Installed power rating
H Tool rotation speed
I Class of protection
L Starter capacitor
INSTALLATION
TRANSPORT
The VIP machine is easy to carry by using the specially provided side handles.
Before carrying the machine make sure that:
• the motor carriage is locked in place with the two cutting adjustment knobs on the slide rail;
• the motor carriage is completely lowered and locked with the locking lever;
• the machine is in the 45° (jolly) position and the inclination adjustment knobs are properly tightened;
• the tube-holder rod is out of its housing.
3 • the feet are closed with the leg locking pin.
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed as follows:
MAKE SURE THAT THE SLIDING CARRIAGE IS LOCKED BY MEANS OF THE CARRIAGE LOCKING
STOPPER. THE MOTOR SLIDE IS LOCKED IN PLACE WITH THE TWO CUTTING ADJUSTMENT KNOBS
ON THE SLIDE RAIL.
Remove the machine from the packaging with the aid of the side carrying handles.
To place the machine in working position, proceed as follows:
4
1) Remove the machine from the packaging with the aid of the side carrying handles.
To place the machine in working position, proceed as follows:
2) Lift the leg making it slide inside the relevant slot.
5
3) Repeat the operation for the front part
4) Insert the tube-holder rod in its seat
6
26
B2 Do not use sector discs
B3 Tool diameter measurements
C1 Recovery tank water level
D1 Warning! Secure the carriage
M IP Level
N Year of manufacture
O Max tool diameter
P Internal tool diameter
Q Accessories
R Accessories
S Manufacturer's name
T Manufacturer's name and address
U Certification Marks
Battipav srl