Motorola Solutions WPLN4137 Mode D'emploi page 8

OPERATING INSTRUCTIONS
Single-unit chargers will charge only the Motorola
Solutions authorized batteries listed in Table 1. Other
batteries may not charge.
The battery charger's pocket will accommodate either a
radio with a battery attached or a battery alone. Prior to
charging a battery with radio, turn the radio off. To
charge a battery, use the following procedure: (Refer to
Figure 1.)
1. Plug the round end of the transformer cord into the
socket on the back of the charger.
2. Plug the transformer into the appropriate AC outlet.
The charger LED will blink green once to indicate a
successful power-up.
3. Insert a battery, or a radio with battery (radio turned
off), into the charger's pocket by:
a. aligning the groove on each side of the battery with
the corresponding raised rail on each side of the
charger pocket
b. pressing the battery toward the rear of the pocket
c. sliding the battery into the charger pocket, ensuring
complete contact between the charger and battery
contacts
6