Technical Information - SPIT F 40 Notice D'emploi Et D'entretien

Technical information

Cutting capacity
Noise
Vibration
Declaration
of conformity
Instructions for use
Before using the
equipment
Switch ON/OFF
6
All manuals and user guides at all-guides.com
Cutting depth .............................................................. max. 40 mm
Cutting width .............................................................. max. 35 mm
Measured values determined to EN 60745-1. Typically the A-weight-
ed noise levels of the tool are:
Sound intensity pressure: L
Sound pressure:
Wear ear protection!
The typical weighted acceleration is 11,6 m/s
We declare under our sole responsibility that this product is in con-
formity with the following standards or standardized documents:
EN 60745-1, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-
3-3, in accordance with the regulations 73/23/EEC, 89/336/EEC,
98/37/EC
Didier BOURRETTE
SPIT S.A., Route de Lyon - B.P. 104, F-26501 Bourg-les-Valence
Consider the main voltage: The voltage of the source of supply is
the same that shown on the information plate on the equipment.
Only switch on the tool just before it will be used. On the rubber body
of the rear handle, two arrows indicate the switch direction.
To switch on the tool, the on/off switch (A) first has to be shifted in
the arrowed direction 1 and afterwards pressed in arrowed direction
2. When the tool has been started, the switch pusher must be kept
in position 2. If it is released, the power supply will be interrupted.
99 dB(A)
WA
L 186 dB(A)
PA
2 .
Jean-Paul BARTHOMEUF