Bodum IBIS 5500 Mode D'emploi page 3

All manuals and user guides at all-guides.com
– Never fill the kettle with water when it is positioned on
the base unit.
– Never fill the kettle above the "MAX" mark visible inter-
nally and externally on the water level gauge.
– Do not allow the power cord to hang over the edge of a
table or work surface, and ensure the power cord does
not come into contact with hot surfaces.
– Do not use appliance for other than intended use.
– Scalding may occur if the lis is removd during the bre-
wing cycles.
If the kettle is overfilled, boiling water may
be ejected.
– Always ensure that you pour out boiling water slowly and
carefully, taking care not to tilt the spout too rapidly.
– To prevent scalding, avoid coming into contact with the
steam escaping from the opening in the hinged lid when
the water is being boiled or just after the kettle has swit-
ched off. Be careful when opening the lid, if the kettle is
still hot and you wish to refill it with water.
Boiling water can cause burns.
– Do not forcefully locate the switch in the ON position, or
make any authorised changes to the switch in order to
make it stay in the ON position. This could lead to steam
escaping from around the lid, damaging the automatic
switch-off mechanism and possibly causing bodily injury.
WARNING
Ensure that the kettle is switched off before
removing it from the base unit.
– Don't use the kettle for any use other than to boil water.
– Move the appliance with extreme care when it contains
hot water.
Do not place the base unit of the kettle on a
metal tray or on any other metal surface,
while it is still connected to a power outlet.
– Do not operate the appliance if the appliance body, the
base unit, the power cord or the plug is damaged. Damage
to the appliance may only be repaired by the manufacturer,
or an authorised dealer, in order to exclude danger.
– Never attempt to connect other appliances to the cordless
base unit and never tamper with the connector in any way
(special interlocked shutters are designed to prevent
access to the live pins until the kettle is positioned on the
base unit).
3