Safety Information - CLAS OM 3060 Mode D'emploi

OM 3060
PAIR OF 6T JACK STANDS WITH SECURITY PINS
CHARCTERISTICS
• Min. H.: 388mm
• Max. H.: 580mm
• Weight: 13,6kg
• Standards: AfPS GS 2014:01 PAK, EK5/AK6 09-12:2009

SAFETY INFORMATION

Please read these safety warnings before operation.
• Failure to heed these warnings may result in a loss of load, damage to the axle stands, and/or
personal injury or property damage.
• Do not overload jack stands beyond their rated capacity.
• Overloading can cause damage or failure of the axle stands.
• Position the load on the centre saddle only, on each axle stand that you use.
• Always use axle stands in pairs, and place on a hard, level surface capable of sustaining the load.
• Use of stands on anything other than a hard level surfacecan result in axle stand instability and
possible loss of load.
OPERATING INSTRUCTIONS
1. Refer to your vehicle owner's manual for proper jacking instructions. Lift only on areas of the
vehicle as specified by the vehicle manufacturer.
2. Position stands under the vehicle at points specified by the vehicle manufacturer as proper load
support points.
3. To adjust the stands hold the control lever up while lifting the saddle shaft to the desired height.
Push the control lever down to lock pawl into the teeth loaded in the centre column. Ensure the
pawl is fully engaged into the teeth.
4. Carefully lower the load onto the stands.
5. Visual inspection should be made before each use of the stands – checking for cracks, cracked
welds and missing and/or damaged parts. An axle stand that appears to be damaged in any way
must be removed from service immediately.
6. Because of the potential hazards associated with the misuse of this equipment, no modifications
should be made to the product.
SADDLE
CENTER
COLUMN
PAWL
CONTROL
LEVER