Installing The Anti-Tip Device - Northland NL24WSG0 Serie Instructions D'installation, D'utilisation Et D'entretien

INSTALLING THE ANTI TIP DEVICE
FOR FREESTANDING INSTALLATIONS
WARNING
!
• ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
• INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
• FOLLOW THE INSTRUC-
TIONS BELOW
Anti-Tip Device
WARNING
!
If your wine cellar is not located under a count-
er top (free standing), you must use an anti-tip
device installed as per these instructions. If
the wine cellar is removed from its location
for any reason, make sure that the device is
properly engaged with the anti-tip bracket when
you push the wine cellar back into the original
location. If the device is not properly engaged,
there is a risk of the wine cellar tipping over,
with the potential for property damage or
personal injury.
NOTE
If installing on a concrete floor, concrete fasteners
are required, (not included with the anti-tip kit).
CAUTION
!
Any finished flooring should be protected with
appropriate material to avoid damage when moving
the unit.
Floor Mount Installation
The anti-tip bracket is to be located on the floor
in the left or right rear corner of the wine cellar as
shown in Figure 7.
All manuals and user guides at all-guides.com
21
(54.6 cm)
Step by step instructions for locating
the position of the bracket:
1) Decide where you want to place the wine cellar.
Slide it into place, being careful not to damage the
floor, leaving 1" (2.5 cm) of clearance from the rear
wall to allow room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
mm) to allow engagement with the anti-tip bracket.
Level the unit by adjusting all the leveling legs as
required. Turning the leveling leg counterclockwise
will raise the unit and clockwise will lower the unit.
3) Make sure the wine cellar is in the desired loca-
tion, then mark on the floor the rear and side corner
of the cabinet where the anti-tip bracket will be
installed. If the installation does not allow marking
the rear corner of the cabinet, then make temporary
lines on the floor marking the front corner of the
cabinet, excluding the door. Slide the wine cellar
out of the way. From the temporary line extend
the sidewall line back 21
Figure 8.
4) Align the anti-tip bracket to the marks on the floor
so the side of the bracket lines up with the side of
the cabinet mark, and the "V" notches on the an-
ti-tip bracket line up with the end of the 21
cm) line (Rear of cabinet line).
5) Fasten the anti-tip bracket to the floor using the
supplied screw. (See Figure 8).
6) Slide the cabinet back into position, making sure
the rear cabinet leveling leg slides under the anti-tip
bracket engaging the slot.
6
Anti-Tip
Bracket
Leveling Leg
Bottom View of
Wine cellar
⁄ "
1
2
Figure 7
1 ⁄ " (54.6 cm) as shown in
2
Front of
cabinet
1 ⁄ " (6
4
1
⁄ " (54.6
2