Troubleshooting; Before You Call For Service - Northland NL24WSG0 Serie Instructions D'installation, D'utilisation Et D'entretien

Before You Call for Service

If the appliance appears to be malfunctioning, read
through this manual first. If the problem persists,
check the troubleshooting guide below. Locate the
problem in the guide and refer to the cause and
its remedy before calling for service. The problem
may be something very simple that can be solved
without a service call. However, it may be required
to contact your dealer or a qualified service tech-
nician.
WARNING
!
Electrocution Hazard
• Never attempt to repair or perform mainte-
nance on the appliance until the main electrical
power has been disconnected. Turning the
appliance control "OFF" does not remove
electrical power from the unit's wiring.
• Replace all parts and panels before operating.
Problem
Appliance not cold enough
(See "Set temperature" on
page 10)
Appliance too cold
(See "Set temperature" on
page 10)
No interior light.
Light will not go out when
door is closed
Noise or Vibration
Appliance will not run.
All manuals and user guides at all-guides.com

TROUBLESHOOTING

In the unlikely event you lose cooling in your unit,
do not unplug the product from the electric
supply, but do call a qualified service technician
immediately. It is possible that the loss of cooling
capacity is a result of excessive frost build-up on
the evaporator cooling coil. In this case, removing
power to the unit will result in the melting of this
excessive quantity of ice, which could generate
melt water that exceeds the capacity of the defrost
drain system and could result in water damage to
your home. The end-user will be ultimately respon-
sible for any water damage caused by prematurely
turning the unit off without appropriately managing
the excess water run-off.
Possible Cause
• Control set too warm
• Content temperature not
stabilized.
• Excessive usage or pro-
longed door openings.
• Airflow to front grille
blocked.
• Door gasket not sealing
properly.
• Control set too cold
• Door gasket not sealing
properly.
• Light bulb is burned out
• Door not activating light
switch.
• Failed light switch
• Appliance not level
• Fan hitting tube obstruc-
tion.
• Appliance turned off
• Power cord not plugged in.
• No power at outlet.
14
CAUTION
!
Remedy
• Adjust temperature colder. Allow
24 hours for temperature to
stabilize.
• Allow temperature to stabilize for
at least 24 hours.
• Airflow must not be obstructed
to front grille. See "clearances"
on page 4.
• Replace door gasket.
• Adjust temperature warmer.
Allow 24 hours for temperature
to stabilize.
• Replace door gasket.
• Replace light bulb, see page 12.
• Appliance not level, level
appliance, (See page 4, "leveling
legs")
• Contact a qualified service
technician.
• Level appliance, see "Leveling
Legs" on page 4.
• Contact a qualified service
technician.
• Turn appliance on. See "Starting
your wine cellar" on page 10.
• Plug in power cord.
• Check house circuit.