Installing Your Wine Cellar; Cabinet Clearances - Northland NL24WSG0 Serie Instructions D'installation, D'utilisation Et D'entretien

INSTALLING YOUR WINE CELLAR

Select Location
The proper location will ensure peak performance
of your wine cellar. We recommend a location
where the unit will be out of direct sunlight and
away from heat sources. To ensure your product
performs to specifications, the recommended
installation location temperature range is from 55 to
100°F (13 to 38°C).
Cabinet Clearance
Ventilation is required from the bottom front of the
wine cellar. Keep this area open and clear of any
obstructions. Adjacent cabinets and counter top
can be installed around the wine cellar as long as
the front grille remains unobstructed.
WARNING
!
An optional stacking kit, for 24" wide models,
is required to stack products. Failure to use a
stacking kit could result in personal injury. Con-
tact your dealer or Northland customer service
at 800-223-3900 to order.
CAUTION
!
Front Grille
Do not obstruct the front grille. The openings within
the front grille allow air to flow through the con-
denser heat exchanger. Restrictions to this air flow
will result in increased energy usage and loss of
cooling capacity. For this reason it is important this
area not be obstructed and the grille openings kept
clean. Northland does not recommend the use of
a custom made grille as air flow may be restricted.
(See Figure 2).
All manuals and user guides at all-guides.com
Leveling Legs
Adjustable legs at the front and rear corners of the
wine cellar should be set so the unit is firmly posi-
tioned on the floor and level from side to side and
front to back. The overall height of your Northland
wine cellar may be adjusted between the minimum,
33
↷) and the maximum, 34
leveling leg out (CCW ↶).
To adjust the leveling legs, place the wine cellar
on a solid surface and protect the floor beneath
the legs to avoid scratching the floor. With the
assistance of another person, lean the wine cellar
back to access the front leveling legs. Raise or
lower the legs to the required dimension by turning
the legs. Repeat this process for the rear by tilting
the wine cellar forward using caution. On a level
surface check the wine cellar for levelness and
adjust accordingly.
The front grille screws may be loosened and the
grille adjusted to the desired height. When adjust-
ment is complete tighten the two front grille screws.
(See Figure 5).
4
Front Grille, keep
this area open.
Front Leveling
Legs
Figure 2
3 ⁄ " (85.7 cm), by turning the leveling leg in (CW
4
3 ⁄ " (88.3 cm) by turning the
4
Rear
Leveling
Legs