Using Your Electronic Control; Starting Your Wine Cellar; Turning Your Wine Cellar On Or Off; Set The Temperature - Northland NL24WSG0 Serie Instructions D'installation, D'utilisation Et D'entretien

USING YOUR ELECTRONIC CONTROL

Alarm
Set Colder Warmer
Press and Hold
Figure 12
close-up of control

Starting your wine cellar

Plug the wine cellar power cord into a wall outlet.
Your wine cellar will begin cooling after power is
applied.
If your wine cellar does not start, check that the
wine cellar is turned on and the set temperature is
cold enough.

Turning your wine cellar ON or OFF

If the wine cellar is on, the wine cellar temperature
will be shown on the display. To turn the wine cellar
off, press and hold the "ON/OFF" button for three
(3) seconds. "OFF" will appear on the display.
If the wine cellar is not on, "OFF" will be shown on
the display. To turn the wine cellar on, press and
hold the "ON/OFF" button for three (3) seconds.
The wine cellar temperature will be shown on the
display.
Set temperature
To set the wine cellar temperature, press and
hold the "SET" button. When the "SET" button is
pressed, the display will show the set tempera-
ture. While holding the "SET" button, press the
"WARMER" or "COLDER" buttons to adjust set
temperature.

Wine cellar operation

The available temperature range of the wine cellar
is 40° to 65°F (4° to 18° C).
It may take up to 24 hours for your wine cellar to
reach desired temperature. This will depend on
amount of content loaded and number of door
opening and closings.
For best results allow wine cellar to "pull down"
to desired set temperature before loading. Once
contents are loaded, allow at least 48 hours for
temperature to stabilize before making any adjust-
ments to the set temperature.
All manuals and user guides at all-guides.com
F
ON/OFF
Press and Hold

Alarms

Your control will monitor wine cellar function and
alert you with a series of audible and visual alarms.
(1) second intervals. The display panel will flash
"do" and the Alarm LED located at the top left of the
display below the word "Alarm" will be illuminated.
This will stop as soon as the door is closed.
ing, a temperature sensor alarm will sound in one
(1) second intervals. "E1" will flash on the display
panel and the Alarm LED located at the top left of
the display below the word "Alarm" will be illuminat-
ed. Please call Northland Customer Service or your
dealer if this error code is displayed.

Alarm Mute

Press any key to mute the audible portion of an
alarm.
This action will only mute the alarm. If the condition
that caused the alarm continues, the alarm code
will continue to flash and will sound for 20 seconds
every 60 minutes.
10
Figure 13
Control
Assembly
Control
Door Switch
Light Switch
•Door Ajar Alarm: If the door has
been left open for over five (5)
minutes, the alarm will sound in one
•Temperature Sensor Fault: If the
controller detects that the tempera-
ture sensor is not properly function-
NOTE