Shelving Configurations - Northland NL24WSG0 Serie Instructions D'installation, D'utilisation Et D'entretien

All manuals and user guides at all-guides.com

SHELVING CONFIGURATIONS

Insert Wine Bottles
Front Bottles (Necks Facing Rear)
The four (4) pull-out shelves each hold eight (8)
Rear Bottles (Necks Facing Front)
bottles. See Figure 14 for typical wine bottle
spacing. Care should be taken when storing extra
tall bottles in the wine cradle at the bottom of the
compartment because they may prevent the door
from closing.
Loading Tips and Suggestions
Two (2) magnums can be placed in the bottle cradle
as long as they are positioned horizontally.
The bottles on the top rack directly under the light
will be exposed to a slightly higher temperature Figure 14
when the light is on. Position your wines accord-
ingly and REMEMBER TO TURN OFF THE LIGHT
WHEN IT IS NO LONGER NEEDED.
Keep wines that you plan to use for everyday drink-
ing and entertaining on the front half of the racks
where labels are completely visible. Place wines
for aging or longer term storing in the rear.
Pull-out Racks
The four (4) pull-out wine racks may be pulled out
approximately seven and a half (7.5) inches to facil-
itate adding or removing bottles. DO NOT lean on
or press down heavily on the wine shelves. Doing
so may damage the shelves and the wine bottles
stored on them. Pull the wine racks out gently and
carefully to minimize unsettling your wine collection.
Avoid pulling out more than one rack at any time to
maintain stability.
Single Bottle Racks
The single level roll out racks allow you to easily Figure 15
view and access your inventory without disturbing
other bottles (see Figure 16).
Figure 16
11