Hoover H-WASH 300 PRO Mode D'emploi page 58

2. INSTALLATION
Remove the 2 or 4 transportation

screws (A) on the back and
remove the 2 or 4 flat washers,
rubber bungs and plastic spacer
tubes (B) as illustrated in figure 1.
If the washing machine is built-

in,
unscrew
transportation screws (A) and
remove the 3 or 4 flat washers,
rubber bungs and plastic spacer
tubes (B).
During the removal of the screws

occasionally spacer tubes fall
inside the product, these can be
remove by tilting the product forward
and recovering them from the floor
or inside the base of the machine.
Cover the open transportation screw

holes with the 2 or 4 plastic caps
included in the instruction bag.
3 4
the or
WARNING:
keep packaging
away from children.
58
materials