Laica HYDROSMART GENOVA Instructions Et Garantie page 12

EN GENOVA tap filter
6) To install the connector with the M adapter, proceed as follows:
Remove the fastening ring from the connector and take the L adapter with Ø21 mm diameter, then assemble the
-
three pieces as described in figure 6A, 6B and 6C.
6A
Loosen the fastening band with a flat head screwdriver and remove the smaller seal inside the adapter M (fig.
-
7A, 7B).
7A
Choose the best seal: only the one with the largest diameter (fig. 8A) or both with one inserted inside the other,
-
pressing firmly and taking extra care over the direction in which they are inserted (fig. 8B).
8A
- Install the adapter M on the tap and tighten the fastening band using a flat
head screwdriver to secure it firmly to the tap (fig. 9A and B).
9A
7) Remove the HYDROSMART™ filter from its packaging and rinse it under running water. Now hook the filter to
the connector as shown in figure 11A, 11B, 11C.
11A
8B
9B
11B
12
6B
7B
- Screw the connector onto
the ring (fig. 10).
10
11C
6C