Cobra microTALK CXT345C Manuel Du Propriétaire page 8

Mode Functions
Mode Functions
Operation
Channel Scan
Your microTALK ® radio can automatically scan channels.
To scan channels:
Mode/Power
1. Press the Mode/Power button until the
Scan icon and the channel numbers appear
on the display.
2. Press the Channel Up or Channel Down button to
Scan Channels
begin scanning channels.
The radio ignores specific privacy
codes while scanning channels.
The Scan icon will continue to be displayed when
Channel Button
scan is on. Your radio will continue to scan all
channels and stop if an incoming transmission is
detected. Your radio will remain on that channel for
10 seconds.
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that channel.
Your radio will remain on that channel and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
c. Press the Lock button to return to Standby.
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that channel/
privacy code. Your radio will remain on that channel/privacy code
and return to Standby mode.
b. Press the Channel Up or Channel Down button to
resume scanning privacy codes. If you do not press any button
within 10 seconds, your radio will automatically resume scanning
privacy codes.
c. Press the Lock button to return to Standby.
English
10
CXT345C_MANL_ENG_GIANT.indd 10-11
Introduction Operation
Privacy Code Scan
•
Your microTALK radio can automatically scan the Privacy Codes (either
CTCSS 01 through 38 or DCS 01 through 83) within one channel. Only
one set of privacy codes (CTCSS or DCS) can be scanned at a time.
To scan privacy codes:
Select Channel
1. While in Standby mode, press the Channel Up or
2. Press the Mode/Power button until either the
Mode/Power
3. Press the Channel Up or Channel Down button
Scan Privacy Codes
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that channel/
privacy code. Your radio will remain on that channel/privacy code
and return to Standby mode.
b. Press the Channel Up or Channel Down button to
resume scanning privacy codes. If you do not press any button
within 10 seconds, your radio will automatically resume scanning
privacy codes.
c. Press the Lock button to return to Standby.
Customer Assistance Warranty
Channel Down button to choose the channel on
which you wish to scan privacy codes.
CTCSS or the DCS icon appears on the display
and the Scan icon and the privacy code numbers
flash on the display.
to begin scanning privacy codes within the
channel you selected.
Nothing Comes Close to a Cobra
•
®
11
2/4/15 2:12 PM