MaxLite MSF Serie Mode D'emploi page 3

Operating Instructions
MaxLite LED Slim Flood Fixtures (200W & 300W)
®
Slipfitter Mount
1.) Remove the luminaire from the packaging.
2.) Connect the input wires coming out of the mounting bracket to the power supply wires. Place the wires into
the pole and place the mount onto the pole. Secure the mount onto the pole by tightening the locking bolts.
3.) Loosen the screw in the center of the mounting bracket and adjust it to the desired angle. Retighten the
screw (Fig. 1).
adjusting Bolt
locking blot
Lamp
AM bracket
wire
support
Yoke Mount
1.) Remove the luminaire from the packaging.
2.) If required, drill two (2) holes into the mounting surface using the yoke mount as a template (Fig. 2).
3.) Insert expansion bolts (anchor bolts) into the holes drilled in step 4 (Fig. 3).
L
4.) Attach the yoke bracket to the fixture using two (2) included bolts (Fig. 4).
5.) Attach the yoke bracket to the surface, loosen the bolts on both sides of the yoke, and adjust the luminaire
(Fig. 5).
to the desired angle. Secure the luminaire in this position by tightening the bolts on both sides of the yoke
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Lamp
AM bracket
support
Expansion Bolt
MSF Series
Page: 3
REV: 03/15/22