Sony MPK-DVF3 Mode D'emploi page 7

For DCR-TRV8E/TRV10E
Use camera mounting shoe B,
spacer (camera mounting shoe C),
and the screw plate.
1 Attach the spacer to shoe B.
2 Attach the screw plate to
position 3 on shoe B so that the
catch on the reverse side of the
shoe clicks into place.
3 Fasten the screw of the screw
plate to the tripod screw hole of
the camcorder and tighten
firmly.
4 Connect the A/V cable of the
shoe to the camcorder's
AUDIO/VIDEO jack.
For DCR-TRV6E/TRV11E/TRV20E
Use camera mounting shoe B, and
D, and the screw plate.
1 Attach the screw plate to the
position 1 on shoe D so that the
catch on the reverse side of the
shoe D clicks into place.
2 Fasten the screw of the screw
plate on shoe D to the tripod
screw hole of the camcorder and
tighten firmly.
3 Attach the screw plate to the
position 2 on shoe B.
4 Fasten the screw of the screw
plate on the shoe B to the screw
hole on the shoe D of the
camcorder tightly.
5 Connect the A/V cable of the
shoe to the camcorder's
AUDIO/VIDEO jack.
Now you are ready to install the camcorder to the marine pack.
Be sure to check that the camera mounting shoe is attached to the camcorder
tightly before you install the camcorder to the marine pack.
Installation
position
of the screw plate
on the camera
3
mounting shoe B
Spacer
(camera mounting
shoe C)
Camera mounting
shoe B
Screw plate
Installation
position
of the screw plate
of the camera
1
mounting shoe D
2
Camera mounting
shoe D
Camera mounting
shoe B
Screw plate
GB
continued
7
-GB