Preparations; Preparing Your Camcorder - Sony MPK-DVF3 Mode D'emploi

Preparations

Preparing your camcorder

Before installing your camcorder in the marine pack, prepare the camcorder according
to this chapter. The DCR-TRV20E is the model used for illustration purposes.
Otherwise, the model name is indicated in the illustrations. Any differences in
procedure are clearly indicated in the text, for example, "DCR-TRV20E only."
The procedure may be different depending on your camcorder type.
For details, please refer to the operating instructions supplied with your camcorder.
1
Remove the lens cap, shoulder strap,
conversion lens, filter or lenshood from
the camcorder.
2
Attach a charged battery pack.
3
Insert a cassette tape.
4
Attach the reflex prevention ring to the lens.
for DCR-TRV7E/TRV9E/TRV20E
for DCR-TRV6E/TRV8E/TRV10E/TRV11E
for DCR-TRV890E/TRV900E
Be sure not too tighten prevention ring.
5
Select the camera mounting shoe.
The camera mounting shoe and the installing position of the screw plate differ on
your camcorder. For details, refer to the table below.
Camera
mounting
shoe
A
B
D
Note
For DCR-TRV7E, use the camera mounting shoe A only. Do not use camera
mounting shoe B, D, and the screw plate.
Position Camcorder
of the
screw
plate
– DCR-TRV7E
1 DCR-TRV9E
2 DCR-TRV6E/TRV11E/
TRV20E/TRV890E/
TRV900E
3 DCR-TRV8E/TRV10E
1 DCR-TRV20E
2 DCR-TRV6E/TRV11E
: ø 37 mm (large)
: ø 30 mm (small)
: not necessary
1
Installation position
of the screw plate
on the camera
mounting shoe B
continued
GB
5
-GB