Headlight - Hoover WINDTUNNEL T Serie Mode D'emploi

headliGht:

how to replace
(available on select models only)
WARNING
!
To reduce the risk of electrical shock, unplug
vacuum before cleaning or servicing.
removing lens
Press Handle Release Pedal and place handle in
low position.
4.21 Using a Phillips screwdriver, remove (2) screws
as shown and lift off lens.
installing bulb
4.22 Pull old bulb straight out of socket. Push new
bulb straight into socket until locked in place.
Excessive force is not required.
Twisting or turning bulb not required.
replacing lens
4.23 Reposition lens and secure with screws.
belt
CAUTION
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
The belt is located under the bottom plate of the
vacuum and should be checked from time to time
to be sure it is in good condition.
when to replace
Replace belt if it is stretched, cut or broken.
To check the belt, refer to Fig. 4.24 - 4.26.
how to replace
4.24 Turn vacuum over so bottom side is facing up.
Rotate red upper latch (A) counter clockwise.
4.25 Slide red lower latch (B) to the unlock position.
4.26 Lift off bottom plate.
4.27 Remove used belt from brushroll (C) then from
motor shaft (metal rod) (D) and discard.
Actual model may vary from images shown.
4.21
!
what to buy:
headlight
Additional bulbs may
be ordered at Hoover.
com or call 1-800-
944-9200. Ask for
Hoover
27313-107.
4.24
!
4.26
12
4.22
4.23
¨
Part No.
4.25
A
4.27
b
D
C