Ups Supervisor Light Diagnostics Software; Configuration Of Special Functions; Battery Test - Meta System Whad 1500 Manuel D'installation Et D'utilisation

V81608A Ist.Uso Whad2000:V81608A Ist.Uso UPS Whad2000
UPS SuperviSor light DIAGNOSTIC SOFTWARE
The UPS is supplied with software for Windows environments (16 and 32 bit) called UPS SuperviSor light.
This software offers the following functions:
- Display of all the operating and diagnostics data in case of problems.
- Configuration of the special functions.
- Automatic shutdown of the local computer (with Windows operating system).
To download a free copy of the software and/or to get a detailed list of the supported systems, visit our In-
ternet website www.metasystem.it.
Windows is a registered brand of Microsoft Corporation.
Connection
The UPS has a standard RS232 interface and it is possible to use this, in conjunction with a computer, to ac-
cess a series of data regarding the operation and the history of the UPS. The function can be used by means
of the UPS SuperviSor light interface programme for Windows (*) environments, by connecting a serial port on
the PC to the interface socket [5] located on the rear of the UPS using a RS 232 cable.
It is also possible to configure the UPS, enabling or disabling the special functions (Hardware).
Dry Port (UPS WHAD 1500)
At first these contacts are Normally Open.
Contact outputs electrical specifications are the followings:
I = 5A
MAX
Definition of Pins on Dry Port (see Fig.4):
PIN
1-6 Switchover to Battery Power
2-7
3-8
4-9
5

CONFIGURATION OF SPECIAL FUNCTIONS

1 - Neutral sensor: The neutral sensor is able to inhibit the operation of the UPS should the neutral potential
move excessively away from that of earth.
2 - Autorestart: This function enables the automatic restarting of the UPS when mains power returns after the
operation of the UPS was blocked due to the end of battery autonomy.
3 - Dip speed: This function is included for use with loads that make brief and repeated peaks of consumption
(for example laser printers). When it is enabled, the intervention of the bypass is delayed for 10 ms which al-
lows the UPS to overcome shorter peaks without it intervening.
4 - Extended PLL lock range: This enables the increase of the range of mains frequencies from +/- 1Hz to +/-
10Hz.
5 - Enable load waiting mode: The UPS can be set to operate in 'load waiting mode' (LWM). This type of ope-
ration enables the automatic switching on and off of the UPS according to whether the connected load is swit-
ched on or off.
6 - 60 Hz operation: The UPS can be set to operate with 60 Hz mains voltage.
For further details of these and other, less important functions, please refer to the in line Help function sup-
plied with the UPS SuperviSor light diagnostics software.

BATTERY TEST

The battery test can be done during UPS operation on mains power as follows:
1. Automatically: after programming by means of the optional shutdown software
2. Every time the UPS is switched on by means of the UPS SuperviSor light software.
The test is done with the UPS operating on mains power (that is without forcing the operation of the UPS onto
battery power) thanks to a particular MetaSystem patented circuit: therefore even if the battery test gives a
negative result, there will be no interruption of the output power.
All manuals and user guides at all-guides.com
V = 50VAC – 30VDC (contacts 1-6, 2-7, 3-8)
MAX
FUNCTION CONTACT
Dry Contact Relay NA
Autonomy riserve Dry Contact Relay NA
Generic Alarm Dry Contact Relay NA
Not Connected Not Connected
Not Connected Not Connected
15
8-04-2008 9:52 Pagina 15
1 5
6 9
Fig.4