Technical Data - Matrix 150.200.040 Mode D'emploi

TECHNICAL DATA

Operating pressure
Max. operating pressure
Flow rate
Maximum pressure
of water supply
Motor rating
Mains voltage 220-230V~/50Hz
Max. water temperature
Hose line
Noise level LPA in dB(A)
Noise level LWA in dB(A)
Vibrations in m/s²
Weight
External dimensions
Protection type
TROUBLESHOOTING
ERROR
The tool is switched on but is not
working.
Fluctuating pressure output.
Water drips out of the pump.
The motor cuts out suddenly.
The pump does not achieve the
required pressure level.
14
All manuals and user guides at all-guides.com
70 bar
120 bar
5 l/Min.
4 bar
1,400W
50 °C
5 m
88 dB
95.3 dB
1.0 m/sec²
5kg
39 x 24 x 27 cm
IP X5
POSSIBLE CAUSE
Either the plug has not been inserted correctly or
the socket is defective or not switched on or the
extension cable is defective.
The mains voltage is inadequate, in other words
lower than the minimum required mains voltage.
The pump is blocked. The overheating guard
has tripped.
The pump is drawing in air.
The valves are soiled, worn or blocked. The pump
seals are worn.
The seals are worn.
The overheating guard has tripped due to
overheating.
The water inlet filter is blocked.
The pump is drawing in air through the hoses or
hose connectors.
The intake/pump valves are blocked or worn.
The pressure drain valve is blocking.
The spray nozzle is defective or worn.
View of the components (pg.2)
High pressure connector
1
Pressure water connector
2
Lance handle
3
Lance nozzle
4
Water supply
5
ON/OFF switch
6
Cleaning product tank
7
REMEDY
Check the plug, socket and fuses.
Ensure that the mains voltage is adequate.
Follow the instructions for restarting after lengthy
storage.
Switch off the tool and allow the motor to cool for several
minutes. Do not block the pressure jet.
Check the hoses and connectors to ensure that they are
air-tight.
Clean and replace or contact your dealer.
Check and replace the seals if necessary or contact your
dealer.
Check that the mains voltage corresponds to the
requirements specified in the technical data. Switch off
the tool and allow it to cool for several minutes.
Clean the water inlet filter.
Check whether all the supply connectors are fastened
securely.
Check the water supply hose for leaks.
Clean or replace the valves.
Undo the regulating screw and tighten it again. Check
and/or replace.