Before Assembly - Matrix 150.200.040 Mode D'emploi

To avoid electrical accidents we recommend that
you use sockets with an upstream, residual current
circuit breaker (with a max. rated trip current of 30
mA).
Do not start the tool if a mains connection cable
or major parts of the tool, for example safety
elements, high pressure hoses or spray gun, are
damaged.
WARNING. Unsuitable extension cables can be
dangerous.
As soon as the tool is switched on the internal
pumps will start to run. The pumps will operate
even if the trigger on the spray gun is not pressed.
If the tool remains switched on for more than
three minutes without the trigger on the spray
gun being pressed, this can cause the motor
and pumps to overheat. Never leave the tool
switched on for more than three minutes without
supervision or without using it.
When using the tool ensure that you have an
adequate water supply. If the is inadequate water
circulation the sealing rings in the tool will be
damaged.
The trigger must be pressed at the latest one
to two minutes after you switch on the tool.
Otherwise the water circulating inside the tool
will quickly reach a critical temperature and the
sealing rings in the tool will be damaged.
WARNING: Do not start the tool in extremely low
temperatures since otherwise the tool may be
damaged by freezing water.
This tool has been designed exclusively for use
with water. Do not use any caustic chemicals in it.
Do not use the tool is there are people in your
immediate vicinity who are not wearing safety
clothing.
The pressure water jet represents a major injury
risk if it is not used properly. Never direct the water
jet at people, live electrical equipment or at the
pressure cleaner itself. Do not direct the water jet
at unstable walls or, for example, stacks of tyres
since the jet may damage them and cause them to
collapse.
Never direct the pressure jet at yourself or other
people, for example to clean clothing or shoes.
Before starting servicing work on the tool, switch it
12
All manuals and user guides at all-guides.com
off and disconnect it from the power supply.
Use only genuine spare parts from the
manufacturer or spare parts that have been
approved by the manufacturer. Otherwise the
safety of the tool cannot be guaranteed. Do not
reuse the tool until the damaged parts have been
repaired and replaced.
The use of incorrect additives may represent a risk.

BEFORE ASSEMBLY

Check all parts for signs of damage before
assembly.
INSTRUCTIONS FOR USE
Connect the tool EXCLUSIVELY to a cold water
supply.
This pressure cleaner will only work correctly if
you press the trigger on the spray gun handle.
- Screw the pressure hose (1) to the pressure water
connector (2) on the tool (B1). Ensure that it is
tight.
- Connect the lance handle (3) and lance nozzle (4)
and secure them by turning them anti-clockwise
(B2).
- Check whether the filter in the water supply
connector (5) is clean and not blocked.
- Secure the hose for the water supply to the
connector (5) using a box nut or a quick-release
coupling (not supplied).
- Ensure that the connection is secure (B3). Ensure
that the hose is not kinked.
- Open the fresh water supply and check the hoses
and connectors for leaks.
- Undo the lock by pressing the yellow securing
knob in the lance handle (B4)
- Press the trigger on the lance handle to remove
any air from the pump and hoses.
- Lock the trigger on the handle whenever it is not
in use to prevent it spraying accidentally (B4).
- Lock the trigger on the handle to prevent its
being pressed accidentally (B5).
- Use only extension cables that are suitable for
outdoor use.
- Check the tool and extension cables at regular
intervals for signs of damage and replace them if
necessary.
- Have the tool cables replaced only by an
12