Clatronic DBC 3388 Mode D'emploi page 37

All manuals and user guides at all-guides.com
1. Pull the screw clamp out of the clamp socket and fold out
through 180°. Push the screw clamp firmly into the other
clamp socket until it clicks into place.
2. Set the stand onto your work surface. Turn the screw
clockwise.
3. To disassemble the stand, loosen the screw by turning anti-
clockwise. Stow the screw clamp back into the recess on
the bottom of the stand. Push it into the clamp socket until it
clicks into place.
Function switch (7) on the stand
Switch setting Symbol
Top
Middle
Bottom
Electrical connection
• Make sure that the iron voltage (see name plate) and the
line voltage match.
• The mains plug should only be inserted into a correctly
installed socket with earthing contact.
Connected Wattage
The station has a total maximum wattage of 2000 W. With this
connected load a separate supply line protected by a 16 A
household circuit breaker is recommended.
CAUTION: OVERLOAD!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device is too
powerful.
Temperature Control on the Iron (12)
The symbols on the control correspond to the following settings:
MIN
Synthetics, nylon, acrylic,
●
rayon
● ●
Wool, silk
● ● ● Cotton, linen
MAX
Water
Please use only distilled water.
Do not fill battery water, water from the clothes dryer and water
containing additives (such as starch, perfume, softener or other
chemicals) into the water reservoir.
This could damage the iron due to residues forming in the
steam chamber. These residues may cause impurities to the
fabric when dropping out of the holes in the soleplate.
Water Tank (13)
The tank volume is 220 ml.
1. Set the steam volume regulator (3) to the " " position (no
2. Set the iron onto the stand or hold it horizontally.
3. Check the MAX mark (14).
4. Fill the water reservoir at the refill opening (2). Close the lid
Function
Ironing without cord
Lock the iron to the stand
Before Initial Use
Ironing with cord
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use, please
Ironing without cord (
You can iron without the cord with or without steam.
The preset temperature is maintained for around 50 seconds
when ironing without the cord. If you want to continue ironing at
this temperature, the iron must be heated up again. To do so,
place it back onto the stand.
Ironing without steam
1. Set the steam volume regulator (3) to the " " position (no
2. Rest the appliance on the stand or stand upright.
3. Only connect the machine to a properly installed safety
4. Set the temperature on the temperature control (12). If you
off
low temperature
medium temperature
high temperature
maximum temperature
5. Always turn the temperature control to "MIN" after use and
Steam Ironing
steam).
of the tank.
Operation
NOTE:
Always set the temperature control to "MIN" before connect-
ing the appliance to a power point, or before disconnecting it.
pass the iron a few times over an old clean cloth.
NOTE:
Sort out the garments according to their ironing temperatures.
steam).
socket.
have sensitive items to iron, please begin with the lowest
temperature.
NOTE:
The control lamp (10) on the iron shows that it is heating up.
As soon as the control lamp goes off the operating tempera-
ture has been reached. Now you can start ironing.
remove the mains plug (The control lamp goes off).
WARNING:
The steam is hot. Danger of scalding!
NOTE:
• For this a high temperature is needed. Turn the tempera-
ture control (12) at least to the " " symbol.
)
37