Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
11. Menu settings
• During recording, press the Stop button to stop recording.
Then press the Menu button to access the settings.
• Use the Up or Down key to select the parameter you want
to edit.
• Then press the Confirm button to save the setting.
• To exit the setup menu, press the Menu key again.
11.1 Parking Monitor (Park Mode)
Switch parking mode on or off. Here you can also set
from which collision strength (G sensor value) the image
should be taken, default is close.
11.2 G-Sensor
The G-sensor detects a severe impact (e.g. in an acci-
dent), then the current data are no longer overwritten.
Here the trigger level can be set to close, low, middle or
high (factory setting: close).
11.3 Sound recording
Check this box if you want to record the sound as well.
11.4 Volume
Here you can adjust the volume of the sound: low, middle
and high.
11.5 Keytone
Activate or deactivate key tones and warnings.
11.6 Frequency
Set the recording frequency here, default is 50 Hz.
GB
24
Publicité
Table des Matières
