Alecto TM-16 Mode D'emploi page 14

manuals and user guides at all-guides.c
RESISTANCE:
To measure resistance, the TM-16 measures the voltage over
the resistance when a known current flows through it after
which it calculates the resistance; therefor it is important to
make measurements only with the power switched OFF.
To reduce measuring-errors, caused by parallel resistors, it is
advisable to remove the resistor from the circuit and not to
touch the metal part of the test leads and/or resistor.
1.
2.
3.
4.
DIODE:
When testing a diode, the LCD readout will show 1... (overload)
when the diode is in back-direction; when the diode is in
conductive-direction, than the meter readout will show the
forward voltage.
The same rules as described by "RESISTANCE" are applicable
during diode measurements.
1.
2.
3.
Connect the red test lead to the V/ Ω /mA input jack and
the black test lead to the COM jack.
Set the rotary/function switch on the desired
Connect the test leads to the resistor.
The display shows the resistance.
Set the selector switch to
Connect the red test lead to the V/ Ω /mA input jack and
the black test lead to the COM jack.
Connect the test leads to the diode.
.
14
Ω
range.