Alecto TM-16 Mode D'emploi page 12

manuals and user guides at all-guides.c
( GB )
GENERAL:
An overload will be displayed by a '1' on the display. Increase
the range.
A negative voltage or current will be displayed by a minus (-)
sign in front of the actual read-out.
AC & DC VOLTAGE:
Exercise extreme care when measuring voltages which are
over 48 volt.
1.
2.
3.
When one of the ranges 500 V(DC) or 500 V(AC) is selected,
the display shows HV to indicate extra precautions due to the
High Voltage.
Select the desired V= (direct voltage) or V~ (alternating
voltage) range. If the magnitude is unknown, always start
at the highest range and reduce until a satisfactory
reading is obtained.
Connect the red test lead to the V/ Ω /mA input jack and
the black test lead to the COM jack.
Connect the test leads to the device or circuit being
measured and read the measured value from the display.
MEASUREMENTS
12