Call Functions; Making A Call - LAZER Link Manuel D'utilisation

cable.
harge
ANSWERING AND ENDING A CALL
attery
When there is an incoming call, the speaker will
ly but
play an acoustic signal.
have
To answer the call, you can say any word out loud
used
into the microphone (E) (for example:" Answer!") or
ge will
press the control button (A) just once, or, as long
as your mobile phone allows it, you can activate
the automatic answering function on the mobile
phone.
To end the call, press the button (A) just once or
wait for the caller to hang up.
k" on
REJECTING AN INCOMING CALL
er-link
To reject an incoming call, you just have to press
the control button (A) twice when you hear a call
acoustic signal.
GPS)

MAKING A CALL

ve to
To make a call, press the control button (A) to
ant to
activate the voice dialing function of the associated
when
mobile (the mobile should be configured to allow
p the
voice dialing, as long as the mobile has this
starts
function).
oking
To make a re-call (repetition of the last dialed
gator,
number), press the control button twice (A).
Link".
It also depends on the mobile's functions and
enter
configuration.
VOLUME ADJUSTMENTS
WITH MOBILE OR NAVIGATOR (GPS)
d the
The Lazer Link device comes programmed with a
audio
volume level that allows perfect listening up to 120
arts to
km/h. Use the volume control of the associated
device to adjust the volume. It is recommended
d the
to set the highest volume level of the Lazer Link
til you
with the control button (A) before the connection
D (A1)
of the other device
ADJUSTMENT")
MEG Lazer Link bichro DEF 2.indd 5
All manuals and user guides at all-guides.com

cALL FUNcTIoNS

(see ??? "INTERCOM VOLUME
LISTENING TO THE MOBILE'S MUSIC
After connecting the Lazer Link to the mobile
phone that can play music by Bluetooth
the music is activated in the mobile it will be
immediately heard through the Lazer Link device.
The music and the volume can only be controlled
from the mobile phone depending on its functions
and configuration. All of the call functions are
maintained when you are listening to music. If you
receive an incoming call, the music stops and
when the call ends it returns. The same happens
when you make a call.
PAIRING IN INTERcom
WITH ANoTHER LAZER LINK DEVIcE
Make sure that the two Lazer Links are switched off
(switch off as well any Bluetooth
be associated to the Lazer Link, such as mobile
phone, GPS, etc.) Press and keep the control
button (A) of both Lazer Links pressed until the LEDs
(A1) on both devices start to flash alternately in Red
and Blue. Then, briefly press the control button of
one of the Lazer Link devices. After a few seconds,
both devices are paired and you can establish the
intercommunication.
When they have been associated, we recommend
switching off both Lazer Links and switching on the
other devices associated to each Lazer Link (GPS,
mobile, etc.) then, switch the Lazer Links back on,
end the activation of the Intercom function by
pressing 2 seconds on the control button (A) of one
of the Lazer Links.
N.B.: It is important to associate each Lazer Link
to its respective Bluetooth device (GPS, mobile,
etc) before the association of the two Lazer Links
between themselves.
- 5 -
, when
®
device that could
®
12/12/12 14:23