Publicité
Les langues disponibles
Les langues disponibles
1. Technical Data
Line voltage: 230 Volt/50 Hz (if not stated otherwise on the ID-label).
Dimensions:
Ocean Light T5 4 x 39 W: approx. 975 x 233 x 50 mm (l x w x h)
Ocean Light T5 4 x 54 W: approx. 1,255 x 233 x 50 mm (l x w x h)
Ocean Light T5 6 x 39 W: approx. 975 x 293 x 50 mm (l x w x h)
Ocean Light T5 6 x 54 W: approx. 1,255 x 293 x 50 mm (l x w x h)
Ocean Light T5 8 x 39 W: approx. 975 x 353 x 50 mm (l x w x h)
Ocean Light T5 8 x 54 W: approx. 1,255 x 353 x 50 mm (l x w x h)
Luminaires: The lights can be equipped with luminaires for sea water or fresh water aquariums.
Version for sea water:
Version for fresh water: aqualine T5: Reef White 10K und Plant Grow
2. Unpacking
On unpacking, please check the lighting system immediately for any damages. In case of any
complaints, please contact your dealer directly.
Included in shipment:
Light: depending on the version, the lights contain the following:
•
sockets for the installation of 4 - 6 or 8 T5 fluorescent lamps, controlled by 2 power cables
-
blue LED-lamps as moonlight with a separate power cable
-
the versions with 6 and 8 T5 lamps have got fans for cooling the lamps. These fans start
-
automatically when the middle fluorescent lamps are switched on. Longlife fans with ball
bearing are used, they are operated with a safety tension of 6 V.
Steel cable suspension
•
3. Safety advices
The lighting system cannot be used as aquarium cover. It has to be mounted only above the
•
aquarium. The minimum distance between lighting and aquarium must be at least 30 cm.
The lighting system may not be operated without the protection glasses.
•
The housing and protection glasses may become hot during operation. Be cautious when
•
touching them!
Before any replacement of bulbs, disconnect the lighting system from the mains and let it cool
•
down. Afterwards, take the lighting down.
When cleaning, take care that no humidity passes the ventilation slits and enters the interior of
•
the lighting system!
Pay attention to a sufficient thermal exchange. Keep the ventilation slits always free! Do not
•
mount the system in enclosures or behind panels. Missing aeration may result in overheating
and damage the electrical components what may be the cause of noise production.
Do not try to repair the lighting system. Please send it in for checking, preferably with a list of
•
defects.
When working on the light, always pull all power supply plugs.
•
4. Installation
The light can be fastened on the aquarium edge with the attached plastic holders or alternatively
with the steel cable at the ceiling.
aqualine T5: Reef White 15K, Reef White 10K und Reef Blue
7
Publicité
