Brizo Sensori T66T0 Serie Instructions De Montage page 5

All manuals and user guides at all-guides.com
3
A.
Optional Extension
Kit Available -
RP72604
1
C.
5
6
Slide O-ring (1) over cartridge and the
A.
bonnet nut (2). The O-ring,
which acts as a spacer to steady the
sleeve, should rest behind the
bonnet nut. Note: Depending on the
location of valve within the wall and
wall thickness, an optional extension kit
(RP72604) can provide
an additional 1 3/4" of wall thickness.
If your model requires a spacer (3), install
B.
it into sleeve (4). Slide the sleeve over the
cartridge, body and O-ring. Ensure sleeve
is properly positioned over the front of
cartridge.
C. Secure the escutcheon (5) to the rough
(2) with the 2 screws provided (6). Do not
overtighten escutcheon screws.
Handle with Axial Screw
D. Remove the top button (7) from the handle
(if already assembled) by pulling straight
up. Select legacy models have a plastic
insert (8) inside the bottom of the handle.
For those models, verify plastic insert is
inside the handle. Make sure valve is in
the full cold position (to the right) and align
lever of lever handle models to the cold
position on the escutcheon and press
handle onto valve stem. Secure handle
with screw provided and press button back
into top of handle.
2
2
4
B.
4
D.
7
8
Handle with Side Screw
Select legacy models have a plastic insert
(8) inside the bottom of the handle. For those
models, verify the plastic insert is inside the
handle. Make sure valve is in the full cold
position and align lever of lever handle models
to the cold position on the escutcheon and
press handle onto valve stem. Secure handle
with set screw provided and install set screw
cover (if included).
5
3
102224 Rev. C