Aircare 3D6100 Manuel D'utilisation Et D'entretien page 5

ABOUT HUMIDITY
Where you set your desired humidity levels depends on your personal comfort level,
the outside temperature and the inside temperature.
NOTE: Recent CDC tests show that the chances of flu transmission are greatly
reduced at levels of 43% humidity.
You may wish to purchase a hygrometer* to measure the humidity level in your
home. The following is a chart of recommended humidity settings. NOTE: We
recommend using Essick Air
reservoir to eliminate bacterial growth. Add bacteriostat according to the instructions
on the bottle.
NOTE: Under no circumstances should you use Water Treatment products
intended for Rotobelt or Ultrasonic humidifiers.
IMPORTANT: Water damage
may result if condensation
starts to form on windows or
walls. Humidity SET point
should be lowered until
condensation no longer forms.
We recommend room humidity
levels do not exceed 50%.
*Model 1990 digital hygrometer is available for purchase by calling 1-800-547-3888
or visiting www.AIRCAREPRODUCTS.com
NOTE: External hygrometer readings and humidistat readings may differ. Humidity
levels can vary significantly even in one room.
OPERATION
Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier
should be placed at least FOUR inches away from any walls and away from heat
registers. Unrestricted airflow into the unit will result in the best efficiency and
performance.
NOTE: This unit has an automatic humidistat located on the cord that senses the
humidity level around the immediate area of the humidifier. It turns the humidifier
on when the relative humidity in your home is below the humidistat setting and will
turn the humidifier off when the relative humidity reaches the humidistat setting.
DIGITAL DISPLAY
PRESS TO
INCREASE
HUMIDITY
®
Bacteriostat Treatment when you refill the water
.
PRESS AND HOLD
TO TURN UNIT ON
PUSH TO ADJUST
FAN SPEED
5
When Outdoor
Temperature is:
°F ° C
-20 -30°
-10° -24°
2° -18°
10° -12°
20° -6°
30° -1°
TO TURN ON/OFF
For initial operation, plug the unit
in (the display will show - -). Press
the speed button and hold for 5
seconds to turn the unit on or off.
FAN SPEED
The 3D6100 has a four speed digital
control panel.
1) Press the SPEED button to
adjust the fan speeds.
2) The speeds: High (F4) - Low (F1)
display on the digital panel.
Recommended
Indoor Relative
Humidity (RH) is
15 - 20%
20 - 25%
25 - 30%
30 - 35%
35 - 40%
40 - 45%