Control Panel - IB RUBINETTERIE MONAMOUR MA800 Instructions De Montage

T1: ON/OFF key starts the colour cycle.
T2: if pressed once, this stops the colour cycle on the current colour.
If pressed again, the colour cycle will resume.
T3: reduces the brightness of the light on a scale of three levels.
Each touch corresponds to one level of brightness.
T4: increases the brightness of the light on a scale of three levels.
Each touch corresponds to one level of brightness.
Switching on initially:
The system performs the initial tests, on completion of which it goes into standby mode; this
standby mode is indicated by the LED lighting up in white.
Switching on the system:
To activate the system, press the T1 button. The system will indicate the activation by lighting up
the LED next to the T1 button. The colour cycle will start automatically.
It is possible to switch off the system at any time by pressing the T1 button. By pressing the T1
button again, the colour cycle will resume from the last colour prior to switching off.
Colour selection:
It is possible to stop the colour cycle at any time by pressing the T2 button corresponding to the
desired colour. By pressing the T2 button again, the colour cycle will resume.
Selecting the brightness of the light:
It is possible to alter the brightness of the light on a scale of three levels by pressing the T3
(reduce) or T4 (increase) buttons. Each touch corresponds to one level of brightness

Control panel:

15