Meec tools 009533 Mode D'emploi page 34

EN
• Recycle used batteries in accordance with
local regulations.
• A small amount of fluid can leak from the
battery during extreme use, or in extreme
temperatures. Follow the instructions
below if you discover fluid on the battery.
• Carefully wipe away the fluid with a cloth.
Avoid contact with battery fluid.
• The battery fluid consists of a solution
containing 25–30% of sodium hydroxide.
Follow the instructions below if battery
fluid comes into contact with your skin or
eyes. On skin contact: rinse immediately
with plenty of fresh water. Neutralise with
a mild acid, such as lemon juice or vinegar.
On eye contact: rinse immediately with
plenty of fresh water for at least 10
minutes. Seek medical attention.
• The battery cells are of the lithium-ion
type. Do not discard batteries with
household waste, in a fire or in water.
Recycle used batteries in accordance with
local regulations.
SAFETY INSTRUCTIONS FOR
CHARGER
• The plug on the charger must match the
power point. Never modify the plug in any
way. Unmodified plugs and matching
outlets reduce the risk of electric shock.
• The charger must only be used with the
type of battery recommended by the
manufacturer. Charging other batteries
can result in an explosion, personal injury
or material damage.
• Do not charge more than two consecutive
batteries without allowing the charger to
cool.
• After charging, unplug the power cord to
the charger and remove the battery from
the charger. Do not leave batteries in the
charger.
• Never carry the product by the power
cord. Do not pull the power cord to pull
out the plug. Keep the power cord away
from heat, oil and sharp edges.
34
• Do not attempt to charge non-
rechargeable batteries.
• The power cord for the charger cannot be
replaced. Do not use the charger if the
power cord or plug are damaged.
• Do not expose the charger to rain or
moisture.
• Do not open the charger.
• Do not insert objects into the ventilation
openings on the charger.
• The charger is only intended for indoor use.
• The battery will get hot during long
periods of use. Allow it to cool for at least
30 minutes before charging.
• The charger and battery can get hot
during the charging. This is quite normal.
• The charger should preferably be used at
room temperature. Do not cover the
battery charger. Do not charge the battery
in direct sunlight or near sources of heat.
• The battery should be charged when it no
longer supplies the tool with enough
power. Do not continue to use the tool
when the battery no longer supplies the
tool with enough power. Charge the
battery according to the instructions. The
battery can be recharged at any time,
even if it is not fully discharged.
• Make sure that the charger terminals are
not short circuited by any metal objects
when the power cord on the charger is
plugged in. Unplug the power cord when
the charger is not in use. Unplug the
power cord before cleaning.
• Never immerse the charger in water or
any other liquid.
• Never allow water to get into the charger
– risk of electric shock. Do not charge
batteries in hot areas.