Hoover EmPower Mode D'emploi page 8

3-6
Grasp end of cartridge filter and gently
pull it away from pre-filter. Remove car-
tridge from assembly.
The pre-filter can be cleaned with a
brush and then rinsed with water. Allow
pre-filter to dry thoroughly.
3-9
Align grooves (I) on pre-filter frame with
ribs (J) in dirt cup.
3-12
K
Lift out filter (K) and hand wash in cold
water with a mild detergent.
Let filter air dry then reposition. Replace
lens and screws.
Should you want to replace this filter, ask
for HOOVER part no. 38765024 (filter
package part no. 40110004).
Do not operate cleaner without any of
the filters in place.
8
3-7
RIGHT
It is recommended that the HEPA car-
tridge filter be cleaned by tapping either
of the ends until no more dust particles
fall from the filter. DO NOT tap the soft,
pleated sides of the filter. It could
damage the filter.
Do not rinse or wash the filter.
3-10
I
J
Slide filter assemby down into cup until
a light snap is felt. Gently pull up on
assembly to ensure that it is seated
properly in the cup. Ensure that no part
of pre-filter screen extends above top
edge of dirt cup.
Replace lid and return cup to cleaner
(Fig. 3-4).
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, HOOVER part No.
27313107.
3-13
Remove lens
from electrical outlet.
Using a screwdriver, remove the two
screws as shown and lift off lens.
WRONG
- Disconnect cleaner
3-8
To re-assemble the filter assembly,
place large knob of cartridge filter in
hole on bottom of pre-filter.
Snap top of cartridge filter into place.
3-11
Cleaning final filter
The final filter assists in returning clean
air to the room.
Using a screwdriver, remove the two
screws as shown and lift off lens.
3-14
Install bulb
- Pull old bulb straight
out of socket. Push new bulb straight
into socket until locked in place. Do not
twist bulb.
Excessive force is not required.