Clearing Blockages - Hoover EmPower Mode D'emploi

Clearing blockages

Disconnect cleaner from electrical
outlet.
Low suction or pick up may be due to a
blockage in the system. Refer to the fol-
lowing steps to check for blockages
continuing with each step until the
blockage is found:
Turn cleaner OFF and disconnect
from electrical outlet.
1. Check fullness of dirt cup and filter
assembly; empty cup and clean filters if
needed.
4-1
Check dirt duct
2. Remove dirt cup, look in duct (A).
3. Clear blockage from dirt duct.
4-2
B
Check airflow path
4. Remove hose end from cleaner.
5. Plug cleaner in and turn ON. Check
for suction at end of hose (B).
a. If there is suction, continue with
step 6.
b. If there is no suction, check for
blockage in hose. Clear out hose.
4-3
Check hose inlet
6. Turn cleaner OFF and unplug.
7. Remove hose end from cleaner.
8. Press hose inlet door open and clear
any blockages.
12
8-04 C1660-900
A
HOOVER and
Printed in Mexico
are registered trademarks
®
56511-C31