Bell & Ross BR-CAL.301 Notice Technique page 5

All manuals and user guides at all-guides.com
Fourth press of Pusher P1: stops the time measurement.
Fifth press of Pusher P2: stops and resets the chronograph.
After using the chronograph, ensure the pushers on the relevant models are screwed back in (rotate clockwise), to ensure
perfect water resistance.
IMPORTANT
. As with all mechanical watches with a date function, quickset date setting (crown in position 2) MUST
Quickset date setting
NOT UNDER ANY CIRCUMSTANCES be carried out between the times of 9 PM (21.00) and 3 AM (03:00).
. Magnetic fields can adversely affect the accuracy of your watch. Also, we would recommend that you avoid
Magnetic fields
placing your watch near electronic devices that may generate large magnetic fields (radio, smartphone, television, computer,
tablet, loudspeakers, etc.).
Water resistance . Once the watch is set, to ensure perfect water resistance, push the crown back to position 1 (type model)
or screw it back in (clockwise) to position 0 (type
MAINTENANCE
After being immersed in seawater, it is recommended to carefully rinse off the watch and strap with fresh water. It is
also recommended to have the water resistance of your watch checked every two years. To ensure a service that meets
the brand's exacting standards, any servicing of your watch must be carried out by the Bell & Ross service centre or
a watchmaker approved by Bell & Ross. Whenever repairs are made during the warranty period, you must present the
Bell & Ross warranty card, duly dated and signed by the retailer at the time the watch was purchased.
A. Minute hand
B. Chronograph seconds hand
C. Hour hand
D. Chronograph 30-minute counter
E. Seconds hand
F. Date
G. Crown
P1. Pusher 1. Start/Stop
P2. Pusher 2. Reset
model). The crown and pushers must never be operated underwater.
Your watch is equipped with a 3- or 4-position crown
Type model (3-position
NON
* Type model (4-position screw-down crown)
*
0. Unscrew the crown (rotate anticlockwise)
1. Wind the movement by hand
(rotate clockwise)
2. Set the date (rotate anticlockwise)
3. Set the time (direction as required)
5
screw-down crown)